[RASMB] Salvaging a key way guide pin

[John Burgner]

If you heat the epoxy to 200 C or so, the epoxy should be soft enough to
pull the pin out without damage.  A heat gun should work.

Best of luck

John Burgner

 

From: rasmb-bounces at rasmb.bbri.org [mailto:rasmb-bounces at rasmb.bbri.org] On
Behalf Of veronesepk at gmail.com
Sent: Tuesday, July 15, 2008 11:16 AM
To: rasmb at rasmb.bbri.org
Subject: [RASMB] Salvaging a key way guide pin

 

Hi all, 
         Anyone on list have any experience removing a key way guide pin? I
have a damaged cell housing that I want to salvage. I've tried dissolving
the epoxy with methylene chloride to loosen the pin, but to now avail. I'm
not concerned about damaging the general cell housing if I can keep the pin
intact. If anyone has any ideas, let me know. 


Thanks, 

Phillip Keith Veronese
Graduate Student
Lucius Lab
Department of Chemistry
University of Alabama at Birmingham
veronese at uab.edu

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://list.rasmb.org/pipermail/rasmb-rasmb.org/attachments/20080715/5fbdc360/attachment-0001.html>